Apply closest join

ApplyClosestJoin.png 

Use Arrange > Apply Closest Join to (re-)apply closest join to objects after editing.

When you are digitizing closed objects, the Closest Join method automatically calculates the closest join between them, saving you having to think about entry and exit points. The Apply Closest Join feature allows you to (re-)apply closest join to objects after editing. The command may be accessed via:

Note: The Apply Closest Join command is only enabled when two or more embroidery objects are selected.

To apply closest join...

If the Closest Join method has been activated via the Setup (or Standard toolbar) > Options > General docker, entry and exit points of objects are automatically joined at the closest point.

connectors00058.png

 

Closest join is not recalculated automatically – long connectors may result.

connectors00061.png

 

Selected embroidery objects are regenerated and Closest Join applied.

connectors00064.png

 

Caution: Any non-sequential embroidery objects in the selection will cause a message to be displayed:

connectors00067.png

 

Tip: Apply Closest Join also to generated offset objects.

OffsetObjectsCJ.png

 

Related topics...